T-DRILL TCC-50 RL Automatic Tube Cutting Center - for cutting of straight
tubes
Advantages of Chipless Cutting
Automatic Rackloader
TCC-50 RL is practical solution if there is a need to cut tube diameters over
25 mm.
The automatic Rackloader is used when the raw material is coming in straight
lengths. There are two lengths of rackloaders, for tube lengths max. 4000 mm and
max. 6000 mm. The rackloader is integrated into the machine closely. Thus the
total length of system has been kept as short as possible.
In cutting of straight tubes TCC-50 offers a remarkable advantage: the
minimizing of rest pieces. This means that TCC-50 is able to change the cutting
length automatically: it can be programmed to cut e.g. 6000 mm long straight
tube so that the rest piece will be as short as possible. In practice we have
noticed that three cutting lenghts is a reasonable amount in minimizing the
length of rest pieces.
It is natural to think that if the TCC-50 is able to cut different lengths,
these lenghts should be able to be sorted automatically so that the operator
need not do it. Therefore TCC-50 is normally provided with an automatic sorting
table. Thus all the three different cut lengths are assorted to a box of their
own and the waste piece to its own. There are available different sorting tables
suitable for maximum cut lengths from 2000 mm to 6000 mm.
